When in Config Mode a node will neither participate in the mesh nor connect to the VPN using the WAN port. Instead, it’ll offer a web interface on the LAN port to aid configuration of the node.
Whether a node is in Config Mode can be determined by a characteristic blinking sequence of the SYS LED:
Activating Config Mode¶
Config Mode is automatically entered at the first boot. You can re-enter Config Mode by pressing and holding the RESET/WPS button for about three seconds. The device should reboot (all LEDs will turn of briefly) and Config Mode will be available.
In general, Config Mode will be offered on the LAN ports. However, there are two practical exceptions:
- Devices with just one network port will run Config Mode on that port.
- Devices with PoE on the WAN port will run Config Mode on the WAN port instead.