Gluon 2022.1.2

Bugfixes

  • Various build-errors which sporadically occur when building with a large thread-count have been fixed

  • Android devices do not lose their IPv6 connectivity after extended idle-time

  • The 802.11s mesh network is now using 802.11ax HE-modes when supported by hardware

Known issues

  • Upgrading EdgeRouter-X from versions before v2020.1.x may lead to a soft-bricked state due to bad blocks on the NAND flash which the NAND driver before this release does not handle well. (#1937)

  • The integration of the BATMAN_V routing algorithm is incomplete.

    • Mesh neighbors don’t appear on the status page. (#1726) Many tools have the BATMAN_IV metric hardcoded, these need to be updated to account for the new throughput metric.

    • Throughput values are not correctly acquired for different interface types. (#1728) This affects virtual interface types like bridges and VXLAN.

  • Default TX power on many Ubiquiti devices is too high, correct offsets are unknown (#94)

    Reducing the TX power in the Advanced Settings is recommended.

  • In configurations without VXLAN, the MAC address of the WAN interface is modified even when Mesh-on-WAN is disabled (#496)

    This may lead to issues in environments where a fixed MAC address is expected (like VMware when promiscuous mode is disallowed).